where is manual fuel reset 2000 vw jetta

You search Auto repair manual PDF about where is manual fuel reset 2000 vw jetta, search results will appear below. If search results do not exist, please search by others keyword.

Ford Focus PRO-FIT Linear Fuel Doors Installation Instructions

Filed Under (Ford) by admin on 31-12-2013

Download Tools you will need: ? Ratchet set ? Flathead screwdriver ? Drill and drill bits (for electric locking fuel door only) ? Small file ? Degreaser ? Clear Rags Parts list (items not to scale):1) Fuel door with pull cable attached (pull cable is on electric locking fuel door only) 2) Wiring harnesses (long and short) with actuator (electric locking fuel door only) 3) L-bracket (x 4) 4) Washer (x 4) 5) Nylock nut (x 4) 6) Long hex bolt (x 4) 7) Short hex bolt (x 6) 8) Fuse taps (3 sizes – electric locking fuel door only) 9) Fuse (electric locking fuel door only) 10) Switch (electric locking fuel door only) 11) Sticky pads (electric locking fuel door only) 12) Tie wraps (electric locking fuel door only) 13) Gas cap 14) Wrenches 15) Black strip caulk (not pictured) PRO-FIT Linear Fuel Doors Ford Focus – Installation Instructions Prep WARNING: Do not perform this install near a flame source due to the risk of fire or explosion from gas fumes.… Read More

2004 Ford Truck Explorer ERRATIC FUEL GAUGE OPERATION

Filed Under (Ford) by admin on 27-12-2013

Download 2004 Ford Truck Explorer 4WD V8-4.6L SOHC VIN W MIL ON WITH DTC P0463 OR ERRATIC FUEL GAUGE OPERATION FORD: 2004-2007 Explorer MERCURY: 2004-2007 Mountaineer This article supersedes TSB 06-16-7 to update the Service Procedure. ISSUE Some 2004-2007 Explorer 4dr/Mountaineer vehicles may exhibit the malfunction indicator lamp (MIL) on with diagnostic trouble code (DTC) P0463 or an erratic fuel gauge concern. This could be from sulphur contamination in the fuel, causing an open or high resistance on the fuel sender card. ACTION Follow the Service Procedure steps to correct the condition. SERVICE PROCEDURE 1. For vehicles with customer symptom of erratic fuel gauge operation (with no MIL on), proceed to Step 1a. For vehicles with a customer symptom including the MIL on, proceed to Step 1b. If unable to verify the concern, do not continue with this TSB. a. Follow the appropriate pinpoint test (PPT) for “Fuel Gauge Inaccurate” in Workshop Manual (WSM), Section 413-01.… Read More

Edelbrock Pro-Flo EFI Fuel Rail for Honda Acura “B”and “D”Series INSTALLATION INSTRUCTIONS

Filed Under (Honda) by admin on 31-12-2013

Download
• DESCRIPTION: The Edelbrock Honda/Acura Fuel rails, Part # 4794,4796, and 4798, have been designed to fit stock, Edelbrock Victor X, or our Edelbrock Performer X manifolds using stock Honda injectors. Part #4795,4797, and 4799 accept Bosch-style injectors. These fuel rails feature a flow-through design 5/8″fuel passage with -8 AN o-ring threads at each end. They are fully CNC machined from aluminum extrusions, polished, then hard anodized for use with racing fuel (including methanol and alcohol). These fuel rails also include a fuel regulator mounting at the end of the rail that can be used with stock or aftermarket regulators, as well as two auxiliary 1/8″NPT ports for pressure gauge, nitrous system fuel supply, etc.  KIT CONTENTS: ?1 – Fuel Rail ?1 – O-Ring, 1/2″I.D. 1/16″Thick ?1 – Fuel Pressure Regulator Adapter ?2 – O-Ring, -8 AN ?1 – 12mm x1.0 Russell Honda Fuel Fitting (#4794,4795,4796 & 4797 Only) ?4 – O-Ring, 8mm I.D.… Read More

Flex Fuel Kit Control Unit Installation Manual

Filed Under (Other Manuals) by admin on 27-06-2013

Download
For use in vehicles with Electronic Multi-Point, Sequential Fuel Injection (MPI), (MPIs) Systems. e.g. Bosch Motronic, VAG MPi, MMFD Multipoint. The true definition of plug and play…Now You Can Get Flex Fuel kit Converter With 7 Different Harness Connector. No cutting or splicing (or damaging) your original main engine wire harness!! EV1 • EV6 • DE1 • NH1 • NI1 • NI2 • TO1 • (See Page 2, 3 For Diffrent Connector Harnes Type). Simply plug apart, plug in and go GREEN. Please read these instructions carefully to ensure correct operation of the Flex Fuel Kit. Abcesso is not responsible for damage caused as a result of incorrect installation. These instructions refer to the installation and operation of the supplied Flex Fuel Kit unit, for use with gasoline, Ehanol (E85), or any mixture of both, in gasoline engines with standard-fit, Electronic Multi-Point (MPI), Sequential Fuel Injection System (MPIs). Vehicles with other Injection Systems, such as LE, KE Jetronic, CPI, TBI, or Direct Fuel Injection, cannot be used with Flex Fuel Kit.… Read More

2000 Honda Accord EX Coupe Repair Instructions

Filed Under (Other Manuals) by admin on 27-02-2014

Download Applies To: 1998-00 Accord L4 – See VEHICLES AFFECTED MIL Comes On With DTCs P0171 and/or P0172 (Supersedes 00-018, dated March 14, 2000) SYMPTOM The MIL (Malfunction Indicator Lamp) comes on with DTCs P0171 (Fuel System Too Lean) and/or P0172 (Fuel System Too Rich) stored in the ECM/PCM . PROBABLE CAUSE Moisture in the fuel pressure regulator. VEHICLES AFFECTED 1998-99 2-door: ALL 1998-99 4-door: ALL 2000 2-door:From VIN 1HGCG3. . .YA000001 thru YA000919 2000 4-door:From VIN 1HGCG6. . .YA000001 thru YA002332 From VIN 1HGCG5. . .YA000001 thru YA012613 From VIN JHMCG5. . .YC000001 thru YC000015 VIN JHMCG6. . .YC000001 CORRECTIVE ACTION Replace the fuel pressure regulator, and reroute the fuel pressure regulator vacuum line. PARTS INFORMATION Fuel Pressure Regulator (All):P/N 16740-PAA-A01, H/C 5429048 Fuel Pressure Regulator Tube Kit A (M/T with cruise control):P/N 06168-PAA-A10, H/C 6383186 Fuel Pressure Regulator Tube Kit B (A/T with cruise control):P/N 06168-PAA-A60, H/C 6383160 Fuel Pressure Regulator Tube Kit C (M/T without cruise control):P/N 06168-PAB- A00, H/C 6383194 Fuel Pressure Regulator Tube Kit D (A/T without cruise control):P/N 06168-PAB- A50, H/C 6383178 REPAIR PROCEDURE 1.… Read More

Honda Electric Fuel Pump Kit Manual Installation Instructions

Filed Under (Honda) by admin on 23-02-2014

Download
Honda Fuel Pump Kit This kit provides all the part and instructions necessary to add an electric fuel pump to the Honda 20 or 24 engine.
Honda Electric Fuel Pump Installation Instructions – On the ignition side of engine, locate the 10 mm bolt at (1). Remove this bolt and attach the fuel pump . Ensure the fuel pump wires are facing upward. – Attach the other side of the fuel pump (2) to the engine cover using the self-tapping screw. – Attach fuel line (5) to the top and bottom of the fuel pump with hose clamps. The top fuel line goes to the opposite side of the engine and connects to the carburetor inlet. (Place the fuel line hose along the muffler side of the air cleaner. Attach the fuel hose to the air cleaner cover using the wire tie and screw.) – Attach the fuel pump black ground wire (6) to the 10 mm bolt located next to the valve cover.… Read More

2002 Crown Victoria/Grand Marquis Fuel Injection Supply Manifold

Filed Under (Ford) by admin on 20-02-2014

Download Fuel Charging and Controls 2002 Crown Victoria/Grand Marquis Workshop Manual REMOVAL AND INSTALLATION. Removal All vehicles WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel-related components. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in personal injury. WARNING: Fuel in the fuel system remains under high pressure even when the engine is not running. Before working on or disconnecting any of the fuel lines or fuel system components, the fuel system pressure must be relieved. Failure to follow these instructions may result in personal injury. 1. Disconnect the battery ground cable (14301). For additional information, refer to Section 414-01 . 2. Relieve the fuel pressure. For additional information, refer to Section 310-00A (Gasoline) or Section 310-00B (Natural Gas). 3. Disconnect the fuel lines. For additional information, refer to Section 310-00A (Gasoline) or Section 310-00B (Natural Gas).… Read More

Honda Civic D-series Racing Intake Manifold Manual Installation Instructions

Filed Under (Honda) by admin on 01-01-2014

Download
Part # 307-05-0260 Racing Intake Manifold For Models and Years • 1992-1995 Honda Civic DX/EX (D15B7/D16Z6) • 1996-2000 Honda Civic EX (D16Y8) • 88-91 Honda CRX Si / DX* (*These models will require additional parts)
Additional Parts List and Installation Notes for CRX Installation Parts Required • 95-95 Civic throttle body and gasket. • 92-95 Civic fuel rail (use 88-91 civic injectors). • 92-95 Civic throttle cable and bracket. • 88-91 CRX intake gasket. • 3 1/2 Feet of vacuum line. • 2 Feet of 3/8″ water hose for “IAC” (lines need to be lengthen). • 1 Vacuum line “T” (to re-connect purge control valve).
Removal 1. Allow car to cool to ambient temperature. DO NOT attempt to work on warm or hot vehicle. 2. Drain coolant. 3. Relieve fuel pressure by loosening banjo bolt on top of fuel filter. Disconnect the fuel line at fuel rail. It is recommended that the washers be replaced.… Read More

1993 Ford Escort FUEL PUMP CIRCUIT (RELAY & INERTIA SWITCH)

Filed Under (Ford) by admin on 31-12-2013

Download 1993 Ford Escort G – TESTS W/CODES – EEC-IV (1.9L)’ ’1993 ENGINE PERFORMANCE Ford Motor Co. – Self-Diagnostics – EEC-IV. CIRCUIT TEST J – FUEL PUMP CIRCUIT (RELAY & INERTIA SWITCH) Diagnostic Aids When ignition switch is in the ON or START position, the PCM connects FUEL PUMP circuit (PCM terminal No. 22) to ground. The fuel pump relay is energized and electrical current flows to the fuel pump. If PCM does not receive ignition PIP signal within 2 seconds, FUEL PUMP circuit is opened and fuel pump operation is terminated. Perform this test when instructed by QUICK TEST or CIRCUIT TEST AA. This test is only intended to diagnose: * Fuel pump relay. * Inertia Fuel Shutoff (IFS) switch. * Wiring harness circuits (B+, VPWR, FUEL PUMP, GND and POWER-TO-PUMP). * Faulty Powertrain Control Module (PCM). Fig. 31: Fuel Pump Monitor Circuit Diagram (Escort & Tracer) 1)Code 87/556: Check VPWR To Fuel Pump Relay Code 87/556 indicates a fuel pump primary circuit failure.… Read More

2000 Volkswagen Beetle Vehicle starts and stalls

Filed Under (Volkswagen (VW)) by admin on 01-01-2014

Download Vehicle Application: 2000 Volkswagen Beetle 2.0L, GAS, Eng Des AEG 2002 Volkswagen Beetle 2.0L, GAS, Eng Des AZG 2000 Volkswagen Jetta GL 2.0L 2002 Volkswagen Eurovan 2.8L 2000 Volkswagen Jetta GLS 2.0L, Eng Cfg L4, Eng Des AEG 2002 Volkswagen Jetta GL 2.0L, Eng Des AVH 2000 Volkswagen Jetta GLS 2.8L, Eng Cfg V6, Eng Des AFP 2002 Volkswagen Jetta GLS 2.0L, Eng Cfg L4, Eng Des AVH 2001 Volkswagen Beetle 2.0L, GAS, Eng Des AVH 2002 Volkswagen Jetta GLS Wagon 1.8L 2001 Volkswagen Jetta GL 2.0L, Eng Des AEG 2003 Volkswagen Jetta GLS 2.0L, Eng Cfg L4, Eng Des AVH, USA/Canada 2001 Volkswagen Jetta GLX 2.8L 2007 Volkswagen Passat 3.6 3.6L 2002 Volkswagen Beetle 1.9L, DIESEL, Turbo, Eng Des ALH Customer Concern: Vehicle starts and stalls. Trouble code P1570 (17978). The security light is flashing. Tests/Procedures: 1. As of model year 2000, Volkswagen has changed the immobilizer system and the 7 digit PIN numbers are no longer available to the aftermarket.… Read More

You might also likeclose