what is the inflatable restraint light mean in a 93 cadillac deville

You search Auto repair manual PDF about what is the inflatable restraint light mean in a 93 cadillac deville, search results will appear below. If search results do not exist, please search by others keyword.

1990-1998 GM Cadillac Deville Ignition Lock Cylinder REMOVAL & INSTALLATION

Filed Under (Cadillac) by admin on 28-03-2014

Download When performing service around Supplemental Inflatable Restraint (SIR) system components or wiring, the SIR system must be disabled. Failure to do so could result in possible air bag deployment, personal injury, or unneeded SIR system repairs. Catera Disconnect the negative battery cable. 1. Remove the steering wheel. 2. Remove the inflatable restraint steering wheel module coil. 3. Insert a small pointed awl or wire into the ignition lock cylinder release pinhole. 4. Pull out the ignition lock cylinder. 5.Fig. Insert a pointed tool into the release pin hole To install: Install the lock cylinder. Look into the hole that receives the lock cylinder on the lower RH side in order to locate the locking lever. 1. Carefully push down on the locking lever using a small flat-bladed tool until an audible click is heard. 2. Place the lock cylinder into the empty hole. 3. 6. Install the inflatable restraint steering wheel module coil.… Read More

2002 Cadillac DeVille DHS V8-4.6L VIN Y

Filed Under (Cadillac) by admin on 31-12-2013

Download 2002 Cadillac DeVille DHS V8-4.6L VIN Y Recall – Fuel Tank Pressure Sensor Malfunction. Product Safety – Fuel Tank Pressure Sensor # 03038A – (03/17/2004) 03038A — Fuel Tank Pressure Sensor 2002-2003 Cadillac DeVille, Seville Equipped with V8 (4.6L) Engine (LD8/L37) 2002-2003 Oldsmobile Aurora Equipped with V8 (4.0L) Engine (L47) 2002-2003 Pontiac Bonneville SSEi This bulletin is being revised to remove the parts restriction on the fuel tank and eliminate the need for the recall identification label. Please discard bulletin 03035, issued October 2003. Condition General Motors has decided that a defect which relates to motor vehicle safety exists in certain 2002-2003 model year Cadillac DeVille and Seville vehicles equipped with a V8 (4.6L) engine (LD8/L37), Oldsmobile Aurora vehicles equipped with a V8 (4.0L) engine (L47), and Pontiac Bonneville SSEi vehicles. The fuel tank pressure sensors in these vehicles are unusually susceptible to malfunctions. If the sensor malfunctions, excessive vacuum can be applied to the fuel tank during self-diagnostic testing.… Read More

1994 Cadillac DeVille Concours Passive Struts

Filed Under (Cadillac) by admin on 01-01-2014

Download Subject: Procedure to Disable Illumination of Service Indicator AFTER the Installation of Passive Struts/Shocks Models: 1992-94 Buick Skylark 1993-96 Buick Park Avenue 1989-92 Cadillac Allante 1991-93 Cadillac Eldorado, Seville 1991-95 Cadillac DeVille 1991-95 Oldsmobile Ninety Eight 1992-93 Oldsmobile Achieva 1994-99 Pontiac Bonneville This bulletin is being revised to clarify when this bulletin may be used to turn the service suspension lamp off. Also, a step has been added to the 1991 Cadillac Eldorado and Seville repair. Please discard Corporate Bulletin Number 00-03-11-001 (Section 3 – Suspension). Refer to the Service Manual page 8D-13 (1989) or 8D-14 (1990-1992). On these vehicles, adjust the BCM Override value “BS08″. To do this, use the warmer/cooler button on the CCDIC to decrease the BCM override value “BS08″ which is displayed when you enter the system by two (2). When the desired number is displayed on the CCDIC, it must be stored by holding the “Elapsed Time” and “Fuel Used” buttons until the new value flashes on and off.… Read More

2008 HONDA CR-V FOG LIGHTS INSTALLATION INSTRUCTIONS

Filed Under (Honda) by admin on 09-12-2013

Download PARTS LIST Right fog light Left fog light Fog light harness Fog light switch harness Right trim Left trim Switch Relay Bracket 15Wire ties 4 Wire ties with clip 2 Tapes 8 Self-tapping screws, 5 x 16 mm. Washer bolt, 6 x 16 mm Flange nut, 6 mm Fuse (20A) TOOLS AND SUPPLIES REQUIRED #2 Phillips screwdriver Flat-tip screwdriver Diagonal cutters Ratchet 10 mm Socket 10 mm Combination wrenches Hook tool Isopropyl alcohol Utility knife Masking tape. INSTALLATION 1. Make sure you have the anti-theft codes for the audio and navigation system (if equipped), and write down the XM radio presets (if equipped). 2. Disconnect the negative cable from the battery. 3. Remove the front bulkhead cover (seven clips). 4. Remove the front bumper (four self-tapping screws, six clips, and two bolts). 5. Remove the five clips from the left inner fender, and pull down the left inner fender. 6.… Read More

2000 Cadillac DeVille Brake Switch Circuit Low Input

Filed Under (Cadillac) by admin on 06-04-2014

Download . Circuit Description The torque converter clutch (TCC) brake switch is used to indicate the status of the brake pedal (applied or released). If the PCM detects an open TCC brake switch (stuck ON) during accelerations, then DTC P0719 sets. DTC P0719 is a type C DTC. Conditions for Running the DTC * No VSS DTCs P0502 or P0503. * DTC P0719 has not passed this ignition cycle. Conditions for Setting the DTC The TCC brake switch input is at 0 volts for 15 minutes and the following conditions occur 8 times without a status change on the TCC brake input: * The vehicle speed is less than 8 km/h (5 mph). * The vehicle accelerates to 32 km/h (20 mph) within 2-6 seconds. * Then the vehicle speed remains above 32 km/h (20 mph) for 6 seconds. Action Taken When the DTC Sets * The PCM does not illuminate the malfunction indicator lamp (MIL).… Read More

2009 HONDA CIVIC 4 DOOR FOG LIGHTS INSTALLATION INSTRUCTIONS

Filed Under (Honda) by admin on 09-12-2013

Download PARTS LIST Right fog light Left fog light Switch harness Fog light harness Sub harness Combination light switch 6Wire ties Clip 2 Self-tapping screws 20 A Fuse (Some may not used.) Relay Ground bolt 2 Spring nuts TOOLS AND SUPPLIES REQUIRED Phillips screwdriver Flat-tip screwdriver Ratchet 10 mm and 12 mm Sockets Blanket Diagonal cutters 5 mm Hex wrench Illustration of Fog Lights installed on the vehicle INSTALLATION 1. Make sure you have the anti-theft codes for the audio system and navigation system (if equipped), then write down the radio presets. 2. Disconnect the negative cable from the battery. 3. Remove the front bulkhead cover (two expansion clips, three clips, and move the right and left fender trims inward). 4. With the help of an assistant, remove the front bumper (four long clips, four center clips, two socket bolts, and two self-tapping screws). To prevent damage, set the front bumper on a blanket.… Read More

2004 Buick LeSabre Shake/Vibration in Steering Wheel

Filed Under (Buick) by admin on 31-12-2013

Download 2004 Buick LeSabre | LeSabre (VIN H) Service Manual. Shake/Vibration in Steering Wheel, Floor, Seat at Highway Speeds on Smooth Roads (Diagnose/Balance Tires/Wheels) Models: 1998-2005 Buick Park Avenue, Park Avenue Ultra 2000-2005 Buick LeSabre 1998-2004 Cadillac Seville (SLS, STS) 2000-2005 Cadillac DeVille (DTS only) 2001-2003 Oldsmobile Aurora 2000-2005 Pontiac Bonneville (17″ Tires only) Condition Some customers may comment on shaking/vibration in the steering wheel, floor or seat while driving at highway speeds (typically between 60-72 mph (96-115 km/h)) on smooth roads. Cause These specific vehicles may be sensitive to various rotating mass assemblies, especially if they are considered to be out-of-balance. Correction 1. Visually inspect the tires and the wheels. Inspect for evidence of the following conditions and correct as necessary: 2. Set the tire pressure to 30 psi (205 kPa) COLD. Subject: Shake/Vibration in Steering Wheel, Floor, Seat at Highway Speeds on Smooth Roads (Diagnose/Balance Tires/Wheels) Models: 1998-2005 Buick Park Avenue, Park Avenue Ultra 2000-2005 Buick LeSabre 1998-2004 Cadillac Seville (SLS, STS) 2000-2005 Cadillac DeVille (DTS only) 2001-2003 Oldsmobile Aurora 2000-2005 Pontiac Bonneville (17″ Tires only) • Missing balance weights 3.… Read More

2000-2004 Audi TT Coupe Brake System

Filed Under (Audi) by admin on 31-12-2013

Download Audi TT Coupe 2000-2004, Audi TT Roadster 2001-2004 – Brake System. ABS/ESP ITT Mark 20 system components, removing and installing Brake light switch (square housing) , removing and installing Note: To ensure a secure fit, the switch may only be installed once. Removing – Remove storage compartment on driver’s side. Repair Manual, Body Interior, Repair Group 68; Storage compartments, covers – Unplug electrical connector. – Remove brake light switch -1- by turning counter-clockwise through 90. Installing Install in reverse sequence; note the following points: – Pull brake light switch plunger fully out. – Press brake pedal down as far as possible by hand. – Guide switch through installation hole and secure by turning 90 clockwise -arrows-. – Release brake pedal. – Make sure proper function of brake lights when brake pedal is pressed and released. Brake light switch (round housing) , removing and installing Note: To ensure a secure fit, the switch may only be installed once.… Read More

2003 Cadillac Escalade Code C0660 will reset.

Filed Under (Cadillac) by admin on 20-12-2013

Download Vehicle Application: 2003 Cadillac Escalade 5.3L, Vin T, USA/Canada 2005 Chevrolet Suburban 1500 LS 5.3L, GAS, Vin T 2003 Cadillac Escalade EXT 6.0L 2005 GMC Yukon XL 1500 Slt 5.3L, FLEX, Vin Z 2005 Chevrolet Suburban 1500 LS 5.3L, FLEX, Vin Z Customer Concern: Code C0660 will reset. Tests/Procedures: 1. Check the RTD fuse located in the underhood fuse block. 2. Check for Battery Voltage (B+) on the Orange wire at the automatic level control air compressor pin F. 3. If less than B+ at pin F, check for a wiring and connection problem between the air compressor and the underhood fuse block. 4. Disconnect the compressor leveling module connector and check the resistance from the positive battery voltage circuit of the exhaust solenoid valve and the control circuit of the exhaust solenoid valve. Should be 30-90 ohms. 5. Check for B+ on the Dark Blue wire pin B at the air compressor with the exhaust solenoid commanded off.… Read More

2003 Honda Accord 4-Door Accessories Fog Light Installation Guide

Filed Under (Honda) by admin on 04-12-2013

Download
TOOL AND SUPPLIES REQUIRED #2 Phillips screwdriver Small flat-tip screwdriver Felt-tip pen 10 mm Combination wrench 10 mm Socket Ratchet Measure 3 mm and 7 mm Drill bits Eye protection (face shield, safety goggles, etc.) File Diagonal cutters 20 mm Hole saw Drill Masking tape Thumbtack Drill stopper Scissors Hacksaw blade.
INSTALLATION Customer Information: The information in this installation instruction is intended for use only by skilled technicians who have the proper tools, equipment, and training to correctly and safely add equipment to your car. These procedures should not be attempted by “do-it-yourselfers.” 1. Make sure you have the anti-theft code for the radio, then write down the frequencies for the preset buttons. 2. Disconnect the negative cable from the battery. Installing Fog Lights 3. Install the left trim to the left bracket A with two 4 x 16 mm self-tapping screws. 4. Install the left fog light to the left trim with the one step-screw (with rubber), step-screw and washer- screw.… Read More

You might also likeclose