1999 Chrysler Truck Blend Door Actuator Replacement

Download 1999 Chrysler Truck Town & Country LWB FWD V6-3.8L VIN L Vehicle Level Heating and Air Conditioning Air Door Air Door Actuator / Motor Service and Repair Blend Door Actuator Replacement. REMOVAL The air conditioning system can be equipped with either a standard, single blend- air door actuator, or it can be equipped with dual actuators. The dual system has separate blend-air controls. This allows for separate control of the driver’s side air, and the passenger side air. 1. Remove the lower left side steering column cover. Refer to Instrument Panel and Systems. 2. Remove ABS control module. 3. Remove blend-air actuator connector. 4. Remove blend-air actuator. INSTALLATION 1. For installation, reverse the above procedures. 2. Perform the HVAC Control Calibration Diagnostic and Cooldown test. Repeating the test is necessary to clear the fault codes.… Read More

2008-Current Buick Enclave 82541 78218 INSTALLATION INSTRUCTIONS

Download MODEL NO. 82541 78218 APPLICATION: 2007-Current Saturn Outlook 2008-Current Buick Enclave 2007-Current GMC Acadia 2009-Current Chevrolet Traverse. COMPLETE PARTS LIST Part Description Quantity 1. Receiver Assembly (1) 2.2372-04 M12-1/75 x 40 Hex Bolt Cl. 10.9 (6) 3.3730-05 1/2 Conical Washer (6) 4.113129 Instruction Sheet (1). 1. Detach rubber muffler hanger from muffler hook. This will allow the muffler to drop down and allow clearance for the hitch installation. The muffler will go back up in the original location after hitch is installed. 2. On bumper skin, remove cutout at yoke location to allow receiver assembly to fit snug under bumper. 3. Lower the muffler enoughto allow hitch assembly to fit up to mounting points on vehicle frame. 4. Attach hitch assembly frame brackets to existing weldnuts in vehicle frame using M12-1/75 x 40 Hex Bolt Cl. 10.9 #2 and 1/2 Conical Washer #3 supplied in hardware kit. Attach hitch assembly yoke at center to existing weldnuts in vehicle frame using M12-1/75 x 40 Hex Bolt Cl.… Read More

2008 Buick Enclave Windshield Installation Instructions

Download 1. Always wear eye and hand protection when working with glass. Make sure you have the right glass and moldings and the urethane systems you are about to use are current. Windshield part numbers are DW1681 and DW1714. 2. Cover the front seats, floorboards, dash and steering wheel with a clean drop cloth or disposable plastic covers. 3. Drape a fender cover over the fender and tape up any vulnerable areas on the vehicle to protect against damage. Tape up the defroster vents to prevent debris from falling into the openings. 4. To remove the rearview mirror, loosen the 20T Torx set screw at the base and slide the mirror off the pad. 5. Remove the windshield-wiper nut covers. 6. Remove the windshield-wiper nuts using a 15-millimeter wrench or socket. Move the wiper arm in an up-and-down motion to break it loose from the post, or use a wiper puller.… Read More

2008-2011 Buick Enclave BX1513 Installation Instructions

Download Motorhome mount tow bars are recommended for use with this baseplate. Due to the design of the removable tabs, the RangeFinderII, Adventurer, and Ambassador tow bars can not be used. The Acclaim tow bar may be used, but will not fold and store on the front of the vehicle. Adapters, except the BX8833 and BX88151, can not be used with this baseplate. Installation Instructions: 1. Remove 12 push pins from the plastic piece covering the top of the under carriage with a fl at screwdriver. (2 push pins on outer edge of vehicle are not pictured in large picture – look to inset circle.) Also remove four additional push pins from the bottom segment of the fascia. Remove push pins and set aside for later reinstallation. 2. Using a Phillips screwdriver, remove a screw connecting the fascia near the headlight. Do this to both sides and set aside bolts for reinstallation later.… Read More

General Motors Accessories Headrest DVD System Display Monitor Inoperative

Download Models: 2004-2007 Buick Rainier 2008 Buick Enclave 2003-2008 Cadillac Escalade Models 2005-2008 Cadillac CTS, SRX, STS 2006-2008 Cadillac DTS 2003-2008 Chevrolet Avalanche, Silverado, Suburban, Tahoe, TrailBlazer Models 2006-2008 Chevrolet Colorado 2007-2008 Chevrolet Equinox, HHR 2003-2008 GMC Envoy Models, Sierra, Yukon Models 2006-2008 GMC Canyon 2007-2008 GMC Acadia 2007-2008 Pontiac Torrent 2005-2008 HUMMER H2 2006-2008 HUMMER H3 2007-2008 Saturn OUTLOOK 2005-2008 Saab 9-7X This bulletin is being revised to update the models affected list. Please discard Corporate Bulletin Number 07-08-44-016 (Section 08 — Body & Accessories). Condition Some customers may comment on an inoperative display monitor or monitors in the GM Accessories Headrest DVD System. Cause This condition may be caused by a loose connection at the display monitor cable connectors. These connectors are located at the lower rear part of both front seats. Two cables are routed to the display monitor in each seat. Correction Do This Don’t Do This Install display monitor cable connector clamps.… Read More

2008 Ford Escape FLUID LEAK TRANSMISSION FLUID COOLER

Download FORD: MERCURY: 2008 Escape 2008 Mariner This article supersedes TSB 08-16-12 to change the OPERATION DESCRIPTION TIME production fix date. 090904A 2008 Escape/Mariner1.1 Hrs. CD4E Transmission: ISSUE Replace The Transmission Some 2008 Escape and Mariner vehicles (excluding Fluid Cooler, Includes Hybrids) built on or before 5/9/2008 and equipped Time To Remove And with a CD4E transmission may exhibit a fluid leak Install Bumper Cover, from the transmission cooler. Evacuate And Charge Air Conditioning System, Top ACTION Off Transmission Fluid (Do Follow the Service Procedure steps to correct the Not Use With 19700A, condition. 19700A7) DEALER CODING SERVICE PROCEDURE CONDITION BASIC PART NO. CODE Replace the transmission / A/C cooler with a new 19712 07 updated part following Workshop Manual (WSM), Section 412-01. PART NUMBER PART NAME 8L8Z-19712-J Transmission / A/C Cooler WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage IMPORTANT: Warranty coverage limits/policies are not altered by a TSB.… Read More

FORD DIESEL ENGINES Hydronic5 Espar Heater System Installation, Troubleshooting, Repair Manual

Download
HYDRONIC 5 for FORD DIESELENGINES Heater Model 25 1920 05 Installs are for models 250/350 4 wheel drive & 4 wheel ABS 2 wheel drive & 4 wheel ABS. Heater Warnings to Installer •Correct installation of this heater is necessary to ensure safe and proper operation. Read and understand this manual before attempting to install the heater. Failure to follow all these instructions could cause serious or fatal injury Explosion Hazard •Heater must be turned off while re-fueling. •Do not install heater in enclosed areas where combustible fumes may be present. Fire Hazard •Install the exhaust system so it will maintain a minimum distance of 50mm(2″) from any flammable or heat sensitive material. •Ensure that the fuel system is intact and there are no leaks. Asphyxiation Hazard •Route the heater exhaust so that exhaust fumes cannot enter any passenger compartments. •If running exhaust components through an enclosed compartment, ensure that it is vented to the outside.… Read More

2005 Ford Truck F 150 2WD Pickup Ignition System, Spark Plug Removal Instructions

Download 2005 Ford Truck F 150 2WD Pickup V8-5.4L SOHC VIN 5 Vehicle Level Engine, Cooling and Exhaust Engine Technical Service Bulletins All Technical Service Bulletins Ignition System, Spark Plug Removal Instructions. FORD: 2005-2008 Mustang 2004-2008 F-150 2005-2008 Expedition, F-Super Duty 2006-2008 Explorer, F-53 Motorhome Chassis 2007-2008 Explorer Sport Trac LINCOLN: 2005-2008 Navigator 2006-2008 Mark LT MERCURY: 2006-2008 Mountaineer This article supersedes TSB 08-1-9 to update Vehicle Applications, Service Procedure and Part List. ISSUE Some 2004-2008 F-150, 2006-2008 Mark LT, 2005-2008 F-Super Duty, Expedition, and Navigator, with 5.4L 3-V engine; 2005-2008 Mustang, 2006-2008 Explorer, Mountaineer, and 2007-2008 Explorer Sport Trac with 4.6L 3-V engine; 2005-2008 F-Super Duty, 2006-2008 and F-Stripped Chassis, with 6.8L 3-V engine may experience difficulty with spark plug removal. This may cause damage to the spark plug and leave part of the spark plug in the cylinder head. Affected engine build dates are as follows: 5.4L 3-V and 6.8L 3-V before 10/9/07, 4.6L 3-V before 11/30/07.… Read More

2008-2009 Buick LaCrosse BX1514 Installation Instructions

Download Due to the design of the removable tabs, the RangeFinderII tow bar can not be used. Adapters, except the BX8833 and BX88151, can not be used with this baseplate. Installation Instructions: 1. Remove two push pins from the top of the plastic cover. Set cover and push pins aside to be reinstalled later. 2. Remove four push pins from the top of the fascia. Set push pins aside to be reinstalled later. 3. Remove the push pin from between the headlights. Do this to both sides of the vehicle. Set push pins aside to be reinstalled later. 4. Using the 7mm socket, remove two metric bolts from just inside wheel well in front of the tire on the edge of the fascia. Do this to both sides of the vehicle. Set bolts aside to be reinstalled later. 5. Using the 7mm socket, remove two metric bolts from underside of fascia, just forward of front tire.… Read More