, search results will appear below. If search results do not exist, please search by others keyword.
Filed Under (Honda) by admin on 02-02-2014
Download : 2001-02 Odyssey – ALL 2003 Odyssey – From VIN 5FNRL1…3B000001 thru 5FNRL1…3B159953 2003 Odyssey – From VIN 2HKRL1…3H500001 thru 2HKRL1…3H514354 2003 Pilot – From VIN 2HKYF1…3H500001 thru 2HKYF1…3H520648 Idle Fluctuation and/or the MIL Is On With DTC P1129 and/or P0505 (Supersedes 04-007, Idle Fluctuation With DTC P1129 , dated February 6, 2004, to update the information marked by the black bars) SYMPTOM The idle fluctuates, and/or the MIL is on with DTC P1129 (high manifold absolute pressure [MAP] sensor signal) and/or P0505 (faulty IAC valve). PROBABLE CAUSE The idle air control (IAC) valve sticks open, the power steering pressure switch wire is broken, or both. CORRECTIVE ACTION Replace the IAC valve, repair the power steering pressure switch wire, or do both. DIAGNOSIS 1. Start the engine, and let it idle until it warms up. Does the idle fluctuate, or is there a customer complaint of an intermittent idle fluctuation?… Read More
Filed Under (Honda) by admin on 02-01-2014
Model Information Release date for Accord Remote Starter System: September 20, 2007 Release date for CR-V and Civic Remote Starter System: End of September 2007 Technical Questions Q: What does the Honda Remote Engine Starter System do? A: The Honda Remote Engine Starter is a two-way remote system that starts and stops your vehicle’s engine anywhere within a 200-foot range. It’s designed to warm up your vehicle in the winter and cool it down in the summer. Q: How much is the Honda Remote Engine Starter? A: Approximately $499.00 without installation for all applicable Honda models. Check with your Honda dealer for the installation cost. Q: Can I install it myself? A: AHM does not recommend that customers install the Honda Remote Engine Starter due to the complexity of its electrical components. Authorized Honda Technicians are professionally trained to safely install the Remote Engine Starter. Q: Can I have my neighborhood audio shop install the Honda Remote Engine Starter?… Read More
Filed Under (Honda) by admin on 14-01-2014
Download Compatibility The HON-SC1 is designed to be compatible with select Honda/Acura vehicles. Please consult table for compatibility listing. Compatible Headunit Types: • CD only Headunits* • CD + Cassette Headunits* • 6-CD changer Headunits* • Touch Screen Monitor Headunits • Non-Touch Screen Monitor Headunits * Note: Radio must have a “SAT” or “XM” button to access SIRIUS audio modes. In addition, the HON-SC1 is compatible with most additional factory audio accessories that might be included, such as: • Rear Seat Audio Control Center • Rear Seat Entertainment (DVD/Monitor) System • Heads up display (HUD) • Steering wheel controls Note: Kit not recommended for vehicles with Technology Package (Please see Acura’s website for details). The HON-SC1 is not compatible with the factory satellite radio antenna that might be installed in the vehicle. For best operation you must install a SIRIUS compatible antenna as supplied with the compatible SIRIUS Satellite Radio tuner.… Read More
Filed Under (Volkswagen (VW)) by admin on 02-01-2014
Download Steering column, assembly WARNING:Special safety precautions and some different procedures apply to vehicles equipped with airbags CAUTION:Before working on the electrical system: Obtain radio anti-theft code. Ignition OFF ! Disconnect battery Ground (GND) strap. Note: After reconnecting battery: Activate vehicle equipment such as radio, clock and power windows as per service procedures and/or Owner’s Manual. On vehicles equipped with OBD II, activate readiness code. Refer to Powertrain Management, Computers and Control Systems, Testing and Inspection, Procedures See: Powertrain Management/Computers and Control Systems/Testing and Inspection For further information on the steering column assembly, refer to Steering and Suspension, Steering, Steering Column, Service and Repair. 1.- Horn pad -Removing, Fig. 1 2.- Horn plate -Removing, Fig. 2 3.- 50 ±10 Nm (37 ±7 ft lb) 4.- Steering wheel -Horn contact ring, Fig. 3 -Lubricate horn ring with universal grease 5.- Steering column switch securing screws 6.- Combination switch -Turn signal switch. -E2- -Headlight dimmer/flasher switch -E4- -Emergency flasher switch -E3- -Removing, Fig.… Read More
Filed Under (Honda) by admin on 02-01-2014
TOOL AND SUPPLIES REQUIRED #2 Phillips screwdriver Flat-tip screwdriver Diagonal cutters Scissors Ratchet 10 mm Socket 10 mm Combination wrenches Drill motor Drill bit (3 mm) 19 mm Hole saw (3/4″) Electrical tape Felt-tip pen Pushpin Eye protection Isopropyl alcohol.
INSTALLATION 1. Make sure you have the anti-theft code for the radio, then write down the frequencies for the preset buttons. 2. Disconnect the negative cable from the battery. If the your vehicle is equipped with a navigation system, go to step 22 ; if not, continue with step 3. 3. Place the shift lever in the N (Neutral) position. 4. Remove the center panel (ten clips and disconnect the connectors). 5. Remove the audio unit (three self-tapping screws, two clips, and disconnect the vehicle connector). 6. Remove the damper arm cover and disconnect the arm. 7. Open the glove box and remove the two stoppers by releasing the two retaining tabs.… Read More
Filed Under (Honda) by admin on 27-03-2014
Download MIL Comes On With DTC P2195 or P2197 (Supersedes 04-038, dated August 10, 2004, to update the information marked with the black bars) SYMPTOM The MIL is on, and DTC P2195 (rear air fuel ratio sensor signal stuck lean) or P2197 (front air fuel ratio sensor signal stuck lean) is set. PROBABLE CAUSE The ECM/PCM software incorrectly interprets sensor inputs, causing the codes to set. REPAIR PROCEDURE NOTE: •Before you update an ECM/PCM, make sure the battery in the vehicle is fully charged. •To prevent ECM/PCM damage, do not operate anything electrical (audio system, brakes, A/C, power windows, moonroof, etc.) during the update. 1. If not already done, load the May 2004 or later i N CD onto the i N master terminal. Loading instructions are included with the CD. 2. Update the ECM/PCM software with the HIM. For updating instructions, refer to Programming the HIM and Updating an ECM/PCM With a Programmed HIM in Service Bulletin 01-023, Updating Control Units/Modules .… Read More
Filed Under (Other Manuals) by admin on 27-02-2014
Download Applies To: 1998-00 Accord L4 – See VEHICLES AFFECTED MIL Comes On With DTCs P0171 and/or P0172 (Supersedes 00-018, dated March 14, 2000) SYMPTOM The MIL (Malfunction Indicator Lamp) comes on with DTCs P0171 (Fuel System Too Lean) and/or P0172 (Fuel System Too Rich) stored in the ECM/PCM . PROBABLE CAUSE Moisture in the fuel pressure regulator. VEHICLES AFFECTED 1998-99 2-door: ALL 1998-99 4-door: ALL 2000 2-door:From VIN 1HGCG3. . .YA000001 thru YA000919 2000 4-door:From VIN 1HGCG6. . .YA000001 thru YA002332 From VIN 1HGCG5. . .YA000001 thru YA012613 From VIN JHMCG5. . .YC000001 thru YC000015 VIN JHMCG6. . .YC000001 CORRECTIVE ACTION Replace the fuel pressure regulator, and reroute the fuel pressure regulator vacuum line. PARTS INFORMATION Fuel Pressure Regulator (All):P/N 16740-PAA-A01, H/C 5429048 Fuel Pressure Regulator Tube Kit A (M/T with cruise control):P/N 06168-PAA-A10, H/C 6383186 Fuel Pressure Regulator Tube Kit B (A/T with cruise control):P/N 06168-PAA-A60, H/C 6383160 Fuel Pressure Regulator Tube Kit C (M/T without cruise control):P/N 06168-PAB- A00, H/C 6383194 Fuel Pressure Regulator Tube Kit D (A/T without cruise control):P/N 06168-PAB- A50, H/C 6383178 REPAIR PROCEDURE 1.… Read More
Filed Under (Honda) by admin on 01-02-2014
The Honda Hornet 600cc machines have claimed the hearts and souls of many For your peace of mind Genuine Honda Accessories are carefully designed, researched and stringently tested to the highest standards. And since they’re Honda approved you’ll know that they’re just as tough and well made as your Honda motorcycle. 1 Magnetic Tank Bag 13ltr Useful magnetic tank bag providing 13 litre capacity. Stores an A4 size file, plus personal belongings. Complete with rain cover. 2 Fly Screen Compact, stylish, brown- tinted acrylic offering substantial relief from the blast of wind at high speeds. Fits CB600F only.3 Sports/Touring Windshield This polycarbonate screen dramatically improves wind protection, offering greater comfort at high speeds. Fits CB600FS only. 4 Meter Ring Chromed ornamental meter ring to add a little extra to the meter panel. Fits CB600F only. Radiator Cap Decorative chrome radiator cap. Cargo Net Useful net to secure luggage to rear carrier and/or pillion seat.… Read More
Filed Under (Honda) by admin on 13-02-2014
Download The AERATechnical Committee offers the following information regarding an engine oil leak on 1989-91 Honda 1.5 & 1.6Lengines. Some vehicles that were produced during the mentioned years may have an oil leak around the spark plug well. The spark plug area of the camshaft holder casting could be porous and may leak. If normal diagnosis and repairs do not fix the above-mentioned concern, installation of a new cam holder kit, Part #041 01-PM3-308, H/C: 3046497, will be required. To properly install the new kit, removal of the spark plugs and valve cover need to be done. Upon removal of the valve cover, inspect valve cover rubber seals. If any signs of damage have occurred, replace rubber seals as needed. Turn the engine to TDC, remove the timing belt adjuster and remove the timing belt and rocker arm assembly. Check clearance between the new camshaft holders and the camshaft by coating the new cam holder with oil and installing them without the rocker arms and shafts.… Read More
Filed Under (Honda) by admin on 09-12-2013
PARTS LIST Roof box 4 Brackets A 4 Brackets B 4 Plates 8 Knobs 8 Bolts 8 Washers 2 Straps Seal 2 Keys 4 Large pads 4 Small pads SUPPLIES REQUIRED Isopropyl alcohol Shop towel.
INSTALLATION NOTE: •Be careful not to damage the roof and other finished surfaces of the body when installing the roof box. •The maximum load capacity for this product is 110 lb (50 kg); approximate product weight is 29 lb (13 kg). •Do not allow the combined weight of the accessory and cargo to exceed the carrying capacity of the roof rack. •Honda roof racks or crossbars are required to install the roof box. 1. Open the roof box. Attach an adhesive seal over each of the unused mounting holes along the bottom of the box. The seals will help prevent water from entering the roof box. 2. Using isopropyl alcohol on a shop towel, clean four brackets B where the small pads will attach.… Read More