2000 windstar tailgate latch

You search Auto repair manual PDF about 2000 windstar tailgate latch, search results will appear below. If search results do not exist, please search by others keyword.

1999-2000 Ford Windstar The battery light is on, but the alternator is charging Has a code P1246

Filed Under (Ford) by admin on 18-01-2014

Download Direct-Hit 2000 Ford Windstar 3.8L Test Details Hotline Archive # 124501 Confirmed Fix Vehicle Application: 1999 Ford Windstar 3.8L, Vin 4 2003 Ford Windstar 3.8L 2000 Ford Windstar 3.8L, Vin 4 Customer Concern: The battery light is on, but the alternator is charging. Has a code P1246. Tests/Procedures: 1. Disconnect the alternator and the Powertrain Control Module (PCM). Check the Violet (VT) (GENerator MONitor or GENMON) wire from the alternator to pin 20 of the PCM connector and the Red/Pink (RD/PK) (GENerator COMmand or GENCOM) wire from the alternator to pin 45 of the PCM for high resistance, an open, or a short to ground. Repair the wiring as needed. 2. If the wiring checks OK, reconnect the PCM and alternator. Start the engine and monitor the VT wire for a roughly 0-10v square wave signal. The signal will be around 40-50% normally with no loads on the system and minimal charging system output.… Read More

FORD RANGER FULL TAILGATE COVER SUGGESTED INSTALLATION INSTRUCTIONS

Filed Under (Ford) by admin on 03-03-2014

Download The full tailgate cover is designed to fit over the complete tailgate with no seams exposed on the rear face of the tailgate. It covers the original handle area so another latch mechanism which operates from the inside of the tailgate may be used. A Tailgate handle relocator kit is available. If this method is to be used, it must be done now before installing the tailgate cover. 1. Tailgate should be removed from the truck. 2. Be sure the latch mechanism is modified and working correctly. After the cover is installed the original mechanism is not accessible. 3. Straighten the tailgate if it is bent or twisted. If installing a louvre cover, paint the rear face of the tailgate with a flat black paint to prevent the original paint from showing through the louvres. Any distortion in the top of the tailgate should be repaired to allow the cover to follow the original tailgate contour.… Read More

2000-2007 Ford Taurus ERRATIC FLUID LEVEL READING ON TRANSAXLE DIPSTICK

Filed Under (Ford) by admin on 15-02-2014

Download Ford : 2000-2007 Taurus 2000-2003 Windstar 2004-2007 Freestar MERCURY: 2000-2005 Sable 2004-2007 Monterey. ISSUE: Some 2000-2007 Taurus, 2000-2005 Sable, 2000-2003 Windstar, and 2004-2007 Freestar/Monterey vehicles, equipped with a 4F50N, AX4N, or AX4S transaxle, may exhibit an erratic fluid level reading on the transaxle dipstick and possible leaks around the filler tube and grommet. The condition may be due to a restricted transaxle vent. ACTION: Repair the transaxle vent restriction by replacing the transaxle vent with a 90° vent stem, small hose clamp, two (2) tie raps, and 24″ (61 cm) of 5/16″ (8 mm) vacuum hose. The 5/16″ (8 mm) vacuum hose will be routed from the 90° vent on the transaxle back to the cowl area, next to the brake master cylinder and tie rapped in place with the end of the hose facing down. Refer to the following Service Procedures. SERVICE PROCEDURE 1. Disconnect the mass air flow (MAF) sensor electrical connector.… Read More

Vehicles Equipped with a Webasto Sunroof System

Filed Under (Other Manuals) by admin on 16-03-2014

Download Models: 1997-2000 Buick Century 1988-1991 Buick Reatta 1988-1999 Buick Riviera 1989-2000 Buick Park Avenue 1998-2000 Buick Regal 1988-1997 Cadillac Seville 1988-1996 Cadillac Fleetwood 1988-2000 Cadillac Eldorado 1989-2000 Cadillac DeVille 1995-2000 Chevrolet Cavalier 1998-2000 Chevrolet Malibu 2000 Chevrolet Impala, Monte Carlo 1988-1995 Oldsmobile Ciera 1989-1996 Oldsmobile Ninety Eight 1994-1998 Oldsmobile Achieva 1995-1999 Oldsmobile Aurora 1997 Oldsmobile Silhouette 1998-1999 Oldsmobile Cutlass 1998-2000 Oldsmobile Intrigue 1999-2000 Oldsmobile Alero 1987 Pontiac 6000 1989-1998 Pontiac Bonneville 1994-2000 Pontiac Grand Am 1995-2000 Pontiac Sunfire 1997-1998 Pontiac Trans Sport 1997-2000 Pontiac Grand Prix 1997-2000 Chevrolet & GMC S/T Models (Blazer, Jimmy) 1997-2000 Oldsmobile Bravada.… Read More

FORD 53-72 SHORT FLARESIDE TAILGATE WITH LATCHES AND LINK ASSEMBLY INSTALLATION INSTRUCTIONS

Filed Under (Ford) by admin on 08-03-2014

Download 1. Assemble the bed and make sure the box is square. Measure the distance between the bedsides at the floor level and the top. This width should be 49″. Also measure cross wise from one front corner to the opposite rear corner in both directions. These measurements should be within 1/16″ of each other. Remove the chain assemblies if so equipped. 2. Place some masking tape over the hinge attaching locations on one of the bedsides. Install the hinges and the new tailgate and make sure it is aligned to your satisfaction. 3. Mark the location of the hinge onto the masking tape so that it may be removed and re-installed in the same exact location. 4. Remove the hinge marked in step # 3 above and remove the tailgate. Install the hinge back into position using the marked masking tape as a guide. 5. Slide the template provided onto the hinge far enough that the template can lay flat against the inside of the bedside.… Read More

FORD F150/250-350: 1987-1996/1998, FORD Ranger: 1993 and up MAZDA B Series: 1994 and up Tailgate Lock PL2300 Installation Instructions

Filed Under (Ford) by admin on 25-02-2014

Download Installation 1. Lower the tailgate and remove the access panel with a Torx T-30 driver. 2. Release the rod ends from the plastic clips of the scissor links by prying the yellow clasps up with a screw driver. 3. Remove the two 10 MM nuts holding the scissor bracket and remove it and remove the handle. 4. Pry the plastic dust cover from the handle and discard it. 5. Slide the LOCK BRACKET over the driver’s side stud on the handle and slide the EL over the passenger’s side stud of the handle. 6. Insert them into the tailgate from the outside. 7. Insert the scissor bracket into the tailgate from the inside. Tighten it down with a nut on the driver’s side. 8. Turn the lock counter clockwise with the slot in the horizontal position. This is important for the next step. 9. Insert the BOLT ASSEMBLY and position it onto the driver’s side stud on top of the scissor link with the other nut.… Read More

Ford Explorer Sport Trac Advanced Folding X5 Supra Cover INSTALLATION INSTRUCTIONS

Filed Under (Ford) by admin on 08-12-2013

Download Advanced Folding X5 Supra Cover 2001-2006 Ford Explorer Sport Trac 2007-2010 Ford Explorer Sport Trac (Part Number’s 28570 & 28572). Suggested Tools Installation Kit â Scissors â 5/16″ Socket or Wrench â 3/8″ Wrench â Ratchet â Hammer â Chisel or knife â 1/8″ Punch or Nail â #1 Phillips Screwdriver â 4 Latch Catches for 28570 â 2 3rdLeg Hinge Brackets for 28570 â 12 Washers â 12 Latch Catch Screws â 2 D-Seals â 2 Nuts and 2 Bolts â Latch Catch Screws. Removing Plastic Plugs 1. Cut off 8 plastic plugs (2 in each corner) with a chisel or knife and push the remaining pieces through the hole using a hammer and nail or punch. Make sure holes are clear. (Fig. 1). 2. Pry 4 plugs out (with a standard screwdriver) of the center of the sides of the truck box (2 each side). (Fig. 2). rail D seal at end of Tailgate Box Seal The torque screws located in the middle of the sides need to be removed according to the instructions.… Read More

2000 Volkswagen Beetle Vehicle starts and stalls

Filed Under (Volkswagen (VW)) by admin on 01-01-2014

Download Vehicle Application: 2000 Volkswagen Beetle 2.0L, GAS, Eng Des AEG 2002 Volkswagen Beetle 2.0L, GAS, Eng Des AZG 2000 Volkswagen Jetta GL 2.0L 2002 Volkswagen Eurovan 2.8L 2000 Volkswagen Jetta GLS 2.0L, Eng Cfg L4, Eng Des AEG 2002 Volkswagen Jetta GL 2.0L, Eng Des AVH 2000 Volkswagen Jetta GLS 2.8L, Eng Cfg V6, Eng Des AFP 2002 Volkswagen Jetta GLS 2.0L, Eng Cfg L4, Eng Des AVH 2001 Volkswagen Beetle 2.0L, GAS, Eng Des AVH 2002 Volkswagen Jetta GLS Wagon 1.8L 2001 Volkswagen Jetta GL 2.0L, Eng Des AEG 2003 Volkswagen Jetta GLS 2.0L, Eng Cfg L4, Eng Des AVH, USA/Canada 2001 Volkswagen Jetta GLX 2.8L 2007 Volkswagen Passat 3.6 3.6L 2002 Volkswagen Beetle 1.9L, DIESEL, Turbo, Eng Des ALH Customer Concern: Vehicle starts and stalls. Trouble code P1570 (17978). The security light is flashing. Tests/Procedures: 1. As of model year 2000, Volkswagen has changed the immobilizer system and the 7 digit PIN numbers are no longer available to the aftermarket.… Read More

2000-2002 AUDI A4 Multi Vehicle Mount MVM-45-05

Filed Under (Audi) by admin on 27-03-2014

Download AUDI A4 – 2000-2002 AUDI S4 – 2000-2002 AUDI A6 – 2000-2005 AUDI-ALLROAD – 2000-2005 Mount Location: To the Right of the Radio. Multi Vehicle Mount MVM-45-05 Includes PHS-203 Ultra Slim Swivel. DASH DISASSEMBLY INSTRUCTION Locate the four slots on the face of the radio. Insert the Audi DIN tools in these four slots until you hear a click or lock. Note: There is a rubber seal that wraps around the radio between the radio and the dash pad. This causes the radio to sit very tightly in the cavity. To loosen this seal and allow the radio to slide out easier, we recommend using a Dash Trim Tool to wedge between both the right and left sides of the radio dash pad. Carefully wiggle the tool to loosen the radio slightly. Grasp the four DIN tools and slide the radio out of its cavity just enough to allow access to the one (1) 5/16″ hex head bolt that holds the climate control in place.… Read More

2000-2002 Infiniti G20 MIL “ON” REAR O2 SENSOR DTC P0138/P0139/P0140

Filed Under (Infiniti) by admin on 03-02-2014

Download If a 2000 to 2002 G20 has a MIL “On” and any of the following DTCs stored in the ECM: • P0138 Heated Oxygen Sensor 2 (Rear) (Bank 1) (Max. Voltage Monitoring) • P0139 Heated Oxygen Sensor 2 (Rear) (Bank 1) (Response Monitoring) • P0140 Heated Oxygen Sensor 2 (Rear) (Bank 1) (High Voltage) Start with the Service Procedure to find out if the bulletin applies to this vehicle. If it does apply, complete the Service Procedure to repair the incident, if it should occur. SERVICE PROCEDURE You will be performing the following, as required: • Determine the DTC Stored in ECM from the CONSULT-II Self-diagnosis results. • ECM Part Number Check to determine if this bulletin applies. • ECM Reprogramming (required if the ECM P/N in the vehicle matches one of those listed under “Current ECM P/N” in Chart A -page 2). • Replacing the Rear Oxygen Sensor (required if ECM Reprogramming is needed).… Read More

You might also likeclose