1999 gmc jimmy air door actuator how to

You search Auto repair manual PDF about 1999 gmc jimmy air door actuator how to, search results will appear below. If search results do not exist, please search by others keyword.

2005 HONDA CR-V DOOR VISORS INSTALLATION INSTRUCTIONS

Filed Under (Honda) by admin on 24-12-2013

Download
PARTS LIST Left front door visor Right front door visor Left rear door visor Right rear door visor Installing the Front Door Visor 1. Lower the front door glass completely. Remove the door glass run channel from the door sash in the area shown. Do not remove the glass run channel from the door mirror base or the rear end of the door. AII 27171 TOOLS REQUIRED Isopropyl alcohol Shop towel Masking tape INSTALLATION NOTE: •These instructions show the left door visors being installed. The same procedure applies to installing of the right door visors. Be careful not to damage the paint finish or glass run channels when installing the door visors. Handle the door visors with care. They are not designed to absorb shock or impact. This door visor kit should be installed only if the ambient air temperature is 60°F (15°C) or above. To allow the adhesive to cure, do not wash the vehicle for 24 hours.… Read More

1999 Chrysler Truck Blend Door Actuator Replacement

Filed Under (Chrysler) by admin on 12-03-2014

Download 1999 Chrysler Truck Town & Country LWB FWD V6-3.8L VIN L Vehicle Level Heating and Air Conditioning Air Door Air Door Actuator / Motor Service and Repair Blend Door Actuator Replacement. REMOVAL The air conditioning system can be equipped with either a standard, single blend- air door actuator, or it can be equipped with dual actuators. The dual system has separate blend-air controls. This allows for separate control of the driver’s side air, and the passenger side air. 1. Remove the lower left side steering column cover. Refer to Instrument Panel and Systems. 2. Remove ABS control module. 3. Remove blend-air actuator connector. 4. Remove blend-air actuator. INSTALLATION 1. For installation, reverse the above procedures. 2. Perform the HVAC Control Calibration Diagnostic and Cooldown test. Repeating the test is necessary to clear the fault codes.… Read More

1993-1999 Peugeot 306 Part 57-0509 Installation Guide

Filed Under (Peugeot) by admin on 24-01-2014

Download Parts list: 1 x Air filter Element 1 x Cold Air Hose Assembly 1 x Literature Pack Fixing kit: – 1 x #48 Hose Clamp 4 x Plastic Ties. INSTALLATION INSTRUCTIONS 1. Disconnect the negative battery terminal from the battery. 2. Unclip, unbolt and remove the air box intake pipe from the vehicle. (Fig. 1) 3. Unclip, unbolt and remove the air box to engine intake pipe from the vehicle. (Fig. 2&3) 4. Remove the rubber seal from the air box neck. (Fig. 4) 5. Using a junior hacksaw cut 4 x 1mm wide slits equally spaced around the air box neck. Remove any loose plastic from the air box (Fig. 5) 6. Unclip the base from the airbox and remove the original filter element. (Fig. 6) 7. Using a hot air gun gently warm the air box neck to aid fitting of the Air filter assembly. 8. Feed the Air filter assembly into the air box and through the air box neck.… Read More

Clunk, Bump or Squawk when Vehicle Comes to Complete Stop

Filed Under (Other Manuals) by admin on 02-04-2014

Download 1999-2000 Cadillac Escalade (Old Style) 2002-2004 Cadillac Escalade, Escalade EXT 2003-2004 Cadillac Escalade ESV 1996-1999 Chevrolet 1500 Series Extended Cab Short Box Pickup (Old Style) 1996-1999 Chevrolet 1500 Series Regular Cab Pickup and Utility Models (Old Style) 1999-2002 Chevrolet Silverado Extended Cab Short Box (New Style) 1999-2004 Chevrolet Silverado 1500 Series Regular Cab (New Style) 2000-2004 Chevrolet 1500 Series Avalanche, Suburban and Tahoe 2001-2004 Chevrolet Silverado 2500/3500 Series Regular Cab with Long Bed or Extended Cab (New Style) 2001-2004 Chevrolet Silverado 2500 Series Crew Cab, Short Box (New Style) 1996-1999 GMC 1500 Series Extended Cab Short Box Pickup (Old Style) 1996-1999 GMC 1500 Series Regular Cab Pickup and Utility Models (Old Style) 1999-2002 GMC Sierra Extended Cab Short Box (New Style) 1999-2004 GMC Sierra 1500 Series Regular Cab (New Style) 2000-2004 GMC 1500 Series Yukon, Yukon XL 2001-2004 GMC Sierra 2500/3500 Series Regular Cab with Long Bed or Extended Cab (New Style) 2001-2004 GMC Sierra 2500 Series Crew Cab, Short Box (New Style) 2003-2005 HUMMER H2 with Four Wheel Drive (4WD) or All Wheel Drive (AWD) and One-Piece Propeller Shaft ONLY.… Read More

2009 Honda Civic 4-Doors Accessories Door Visors Installation Manual

Filed Under (Honda) by admin on 13-10-2013

Download
TOOLS AND SUPPLIES REQUIRED Isopropyl alcohol Shop towel Masking tape 6 in. Scale
INSTALLATION Customer Information: The information in this installation instruction is intended for use only by skilled technicians who have the proper tools, equipment, and training to correctly and safely add equipment to your vehicle. These procedures should not be attempted by “do-it-yourselfers.” NOTE: •Visors may not be legal in all states. Please check the laws of your state. •Be careful not to damage the paint finish and glass run channels when installing the door visors. •Handle the door visors with care. They are not designed to absorb shock or impact. •This door visor kit should only be installed if the ambient air temperature is 60°F (15°C) or above. •To allow the adhesive to cure, do not wash the vehicle for 24 hours. Installing the Rear Door Visor 1. Fully open the left rear door window. 2. Install one bracket (C) and one bracket (D) on the door sash at the measurements shown.… Read More

1999-2001 Peugeot 306 HDi Part 57-0469 Installation Guide

Filed Under (Peugeot) by admin on 31-12-2013

Download
Parts list: 1 x Air filter Element. 1 x Rubber Filter Adaptor. 1 x Flexi Cold Air Hose. 1 x Literature Pack. 1 x Fixing Kit :- 1 x #48 Hose Clip. 1 x #64 Hose Clip. 1 x Saddle Bracket. 1 x Mounting Bracket 1 x Flat Metal Washer. 1 x M6 Nylock Nut. 1 x Allen Head Bolt. 1 x Nylon Conical Washer. 3 x Plastic Ties. 1 x 5/16″ Spring Washer. 1 x 8mm Flat Washer.
INSTALLATION INSTRUCTIONS
1. Disconnect the negative terminal from the vehicle battery. 2. Unclip & remove the electrical harness plug from the MAS (Mass Air Sensor). (Fig. 1) 3. Unclip & remove the intake pipe from the MAS. (Fig. 2&3) 4. Unscrew & remove the air box lid / filter element from the air box base. (Fig. 4&5) 5. Assemble the mounting bracket / saddle bracket assembly using the allen head bolt, nylon conical washer, flat metal washer & nylock nut supplied.… Read More

2003 BMW 325I Sport Wagon Check engine light on and fault codes stored

Filed Under (BMW) by admin on 19-03-2014

Download 2002 BMW 325I 2.5L 2003 BMW 325I Sport Wagon 2.5L, Eng Des M54, USA Customer Concern: Check engine light on and fault codes stored. Vehicle running normally. Tests/Procedures: 1. Based upon stored fault codes for secondary air system, there is little or no flow of secondary air into engine. Typical causes for this issue are failed secondary air pumps and/or secondary air check valves. Secondary air pump should operate under normal circumstances when vehicle is first started to perform system test. Pump will normally be heard running when standing in front right corner of vehicle. 2. The secondary air pump is located in the right front of engine compartment. A secondary air pump relay located in the glove box is controlled by the engine control module and sends power to the secondary air pump. 3. Air pump can be disconnected and supplied with power and ground at pump to verify operation is possible.… Read More

Information on Error Codes on Radio Display – Their Cause and Corrective Action

Filed Under (Other Manuals) by admin on 25-12-2013

Download odels: 1995-1996 Buick Roadmaster 1995-1999 Buick LeSabre 1995-2004 Buick Century, Regal 1995-2005 Buick Park Avenue 1996-1999 Buick Riviera, Skylark 2004-2005 Buick Rainier 1995-1999 Chevrolet Lumina, Monte Carlo, Fullsize Pickup Models (Old Style) 1995-2005 Chevrolet Blazer 1996 Chevrolet Lumina APV 1996-1999 Chevrolet Cavalier 1996-2000 Chevrolet Express Van 1996-2002 Chevrolet Astro Van 1997-2002 Chevrolet Camaro 1997-2003 Chevrolet Malibu 1997-2005 Chevrolet Corvette, Venture 2000-2005 Chevrolet Silverado 2002-2005 Chevrolet Avalanche, TrailBlazer, TrailBlazer EXT 2003-2005 Chevrolet SSR 2004-2005 Chevrolet Classic, Colorado 1995-1999 GMC Fullsize Pickup Models (Old Style) 1995-2002 GMC Jimmy 1996-2000 GMC Savana Van 1996-2002 GMC Safari Van 2000-2005 GMC Sierra 2002-2005 GMC Envoy, Envoy XL 2004-2005 GMC Canyon, Envoy XUV 1995-1999 Oldsmobile Aurora, Eighty Eight 1995-1997 Oldsmobile Cutlass Supreme 1999-2004 Oldsmobile Alero 1998-2002 Oldsmobile Intrigue 1995-1996 Oldsmobile Ninety Eight 1996-1999 Oldsmobile Achieva 1996-2004 Oldsmobile Bravada, Silhouette 1995-1999 Pontiac Bonneville, Sunfire 1995-2002 Pontiac Firebird 1995-2005 Pontiac Grand Prix 1996-1997 Pontiac Trans Sport 1996-2000 Pontiac Grand Am 1997-2005 Pontiac Montana 2003-2005 HUMMER H2.… Read More

8005 & 8005TK FORD 1999 to current Super Duty F250, F350, F450, F550 and Excursion with stock manual mirrors Installation Instructions

Filed Under (Ford) by admin on 25-12-2013

Download Do not attempt to manually extend or retract the mirrors. They should be moved under their motor power only!! Tools required for the installation are: 7/16″, 5 mm & 9/32″ sockets, a small screw driver, electrical tape and a sharp tool for cutting a hole for the in/out switch. Model 8005TK will also require a volt meter. If you have any questions after reading this installation manual, please call our service department at (800) 337-2557 REMOVAL OF EXISTING MIRROR: 1. Remove the trim panel on both doors (note – Ford doors do not have retaining clips located around the doors as other models have). To remove the trim panels, start by removing the trim panel on the front side of the window. Remove the plastic panel that holds the electric windows and door locks (to remove this panel pry up from the front or tip of the panel). After you have removed the plastic panel unscrew the 9/32″ screw seen in the back of the hole.… Read More

2004-2008 FORD F150 2WD & 4WD HEAVY LOADS HP10004 AIR SUSPENSION KIT

Filed Under (Ford) by admin on 02-01-2014

Download FORD F150 INSTALLATION MANUAL – L5681 PG. 2 Thank you and congratulations on the purchase of a Pacbrake air suspension kit. IMPORTANT: This air suspension kit will not increase the GVWR (Gross Vehicle Weight Rating), as the GVWR is determined by the axle rating. Do not exceed the maximum capacity listed by the vehicle manufacturer. Before starting, ensure the application information is correct for the make, model and year of the vehicle you are installing it on. Please read the entire installation manual prior to starting the installation to ensure you can complete the installation once started. Pacbrake recommends using a good quality anti-seize on all fasteners, this will reduce the chances of corrosion of the fasteners, and help facilitate removal if required at a later date. 1 PREASSEMBLY OF THE AIR SPRINGS 1. Install the roll plate (with the rounded end towards the air spring) on to the bottom of the air spring.… Read More

You might also likeclose