". You can read and download the PDF file on this page, or you can watch the video tutorial. Please use another keyword if these document aren't what you look for.
2003 Alvalanche with a 5.3 showing above codes, shows multi misfire. Idles rough at times, mileage is bad. Replaced MAS. Reset and cleared codes..
I own a 2004 impala 3.4L. So the other day on my way to work my car stalled at a stop light and room a few cranks to fire up and after it did it ran rough until I got.
hi, i have an 03 chevy 2500hd with the 6.0l about three weeks ago it started throughin code p0101 but it wouldnt stay on i let it go for a week and then it started.
Filed Under (Other Manuals) by Doe Namblas on 28-12-2013
Download Models: 2004-2005 Cadillac Escalade 2004-2005 Chevrolet Avalanche, Silverado 1500, Suburban, Tahoe 2005 Chevrolet Silverado Hybrid (HP2) 2004-2005 GMC Sierra 1500, Yukon, Yukon XL 2005 GMC Sierra Hybrid (PH2) with Vortec 5300 5.3L V-8 Engine (VINs T, Z, B — RPOs LM7, L59, L33) Condition Some customers may comment on a Malfunction Indicator Lamp (MIL) On or that the MIL is flashing. An actual engine misfire may or may not be felt along with an incorrect idle speed. Typically this occurs during cold winter months, on cold engine starts. Some vehicles may have been previously serviced for the same condition. Technicians may also find the following DTCs stored with the Tech 2® P0131, P0133, P0134, P0137, P0138, P0140, P0151, P0153, P0154, P0157, P1133, which may be in conjunction with P0171, P0174, P0300 and P1138. Cause Water shock occurs when water droplets are present in the exhaust. The water in the exhaust contacts the sensor element inside the HO2 sensor, causing the HO2 sensor element to crack.… Read More
Download LM7, L59 or L33 Engines with Cold Start Rough or Incorrect Idle, Misfire, Malfunction Indicator Lamp (MIL) or Flashing Requiring O2 Sensor Replacement (Reprogram PCM)
Filed Under (Ford) by Doe Namblas on 08-12-2013
Download 1. With the truck parked on a clean, dry, and level surface set the parking brake. Chock the rear wheels. Using a floor jack raise the front of the truck and support the frame rail with approved jack stands. NEVER WORK UNDER AN UNSUPPORTED VEHICLE. 2. Using a 22 mm socket remove the lug nuts on the front wheels and remove the front wheels. 3. Measure the amount of thread showing on the torsion bar adjuster bolts. See Photo 1. Drivers Side ______ Passenger Side ______ Using a 18mm socket remove the adjuster bolt . 4. Remove the shock absorbers using a XX wrench. Retain factory hardware for reuse. 5. Using a Ford approved torsion bar tool as shown in Photo 2 to relieve the pressure from the adjuster bolt and treaded adjuster block. See Photo 2. 92754400 97-03 FORD TORSION BAR KEYS Thank you for choosing Rough Country for your suspension needs .… Read More
Download 1997 – 2003 FORD TORSION BAR KEYS INSTALLATION INSTRUCTIONS
Filed Under (Cadillac) by Doe Namblas on 20-12-2013
Download Vehicle Application: 2003 Cadillac Escalade 5.3L, Vin T, USA/Canada 2005 Chevrolet Suburban 1500 LS 5.3L, GAS, Vin T 2003 Cadillac Escalade EXT 6.0L 2005 GMC Yukon XL 1500 Slt 5.3L, FLEX, Vin Z 2005 Chevrolet Suburban 1500 LS 5.3L, FLEX, Vin Z Customer Concern: Code C0660 will reset. Tests/Procedures: 1. Check the RTD fuse located in the underhood fuse block. 2. Check for Battery Voltage (B+) on the Orange wire at the automatic level control air compressor pin F. 3. If less than B+ at pin F, check for a wiring and connection problem between the air compressor and the underhood fuse block. 4. Disconnect the compressor leveling module connector and check the resistance from the positive battery voltage circuit of the exhaust solenoid valve and the control circuit of the exhaust solenoid valve. Should be 30-90 ohms. 5. Check for B+ on the Dark Blue wire pin B at the air compressor with the exhaust solenoid commanded off.… Read More
Download 2003 Cadillac Escalade Code C0660 will reset.
Filed Under (Ford) by Doe Namblas on 18-01-2014
Download Direct-Hit 2000 Ford Windstar 3.8L Test Details Hotline Archive # 124501 Confirmed Fix Vehicle Application: 1999 Ford Windstar 3.8L, Vin 4 2003 Ford Windstar 3.8L 2000 Ford Windstar 3.8L, Vin 4 Customer Concern: The battery light is on, but the alternator is charging. Has a code P1246. Tests/Procedures: 1. Disconnect the alternator and the Powertrain Control Module (PCM). Check the Violet (VT) (GENerator MONitor or GENMON) wire from the alternator to pin 20 of the PCM connector and the Red/Pink (RD/PK) (GENerator COMmand or GENCOM) wire from the alternator to pin 45 of the PCM for high resistance, an open, or a short to ground. Repair the wiring as needed. 2. If the wiring checks OK, reconnect the PCM and alternator. Start the engine and monitor the VT wire for a roughly 0-10v square wave signal. The signal will be around 40-50% normally with no loads on the system and minimal charging system output.… Read More
Download 1999-2000 Ford Windstar The battery light is on, but the alternator is charging Has a code P1246
Filed Under (Ford) by Doe Namblas on 01-01-2014
Download 1998-2002 Continental FORD: 1998-2006 Town Car 1996-1999 Taurus SHO 2000-2006 LS 1998-2006 Crown Victoria, Mustang 1998-2006 Navigator 2000 Taurus 2002-2003 Blackwood 2002-2005 Thunderbird 2003-2005 Aviator 2003-2006 Focus 2004-2006 Taurus MERCURY: 2005-2006 Five Hundred, Freestyle 1998-2006 Grand Marquis 1997-2006 E-Series, Expedition, F-150 2000 Sable 1999-2006 F-Super Duty 2004-2005 Sable 2000-2005 Excursion, F-53 2005-2006 Montego 2001-2006 Escape 2002-2005 Mountaineer 2002-2005 Explorer 2005-2006 Mariner 2005-2006 Escape Hybrid 2006 Mariner Hybrid LINCOLN: 1997-1998 Mark VIII. This article supersedes TSB 04-16-01 to update the SERVICE PROCEDURE vehicle applications and model years. The optional WDS COP Kit available through NOTE Rotunda will provide more accurate diagnosis and help reduce replacement of non-defective parts. The FOLLOW THIS TSB PROCEDURE ONLY IF Kit (418-FS528) can be purchased through THERE ARE NO SPECIFIC MISFIRE TSBs/SSMs 1-800-ROTUNDA. RELEASED FOR THE VEHICLE SYMPTOM BEING EXPERIENCED. The following material will detail the diagnostic steps on WDS to take the guesswork out of misfire ISSUE diagnosis using the COP Kit.… Read More
Download WDS COP KIT DIAGNOSTIC TIPS COIL ON PLUG (COP) IGNITION SYSTEMS ENGINE MISFIRE OR ROUGH RUNNING
Filed Under (Other Manuals) by Doe Namblas on 01-03-2014
INTRODUCTION GEMINI 7039E. The system Gemini 7039E is a module studied to control the vehicle central door locking. It can be installed on vehicle with 12 or 24 volts battery (negative to earth). DESCRIPTION – Remote controlled module to open/close the vehicle doors with dynamic code ( frequency 433.92 MHz ). – Blinker. – Central door locking, electric windows and sunroof closure control (for vehicle equipped with Pack-comfort system). The system Gemini 7039 is equipped with N. 2 transmitters (Art.7218E). INSTALLATION INSTRUCTIONS (for the installer). – Connect the feeding wire to the battery positive terminal and the earth directly to the vehicle frame. – Avoid routing connections next to interference source (plug wires high voltage coil etc.) DIP SWITCH PROGRAMMING TABLE 1 ON Self-learning of a new active code. 1 OFF Self-learning of a new isolated code ( normal use) 2 OFF Not used 3 ON Central door locking control: 6 sec.… Read More
Download GEMINI 7039E Remote Control Alarm Installation Guide
Filed Under (Saturn) by Doe Namblas on 24-02-2014
Download 1999 Saturn SL1 L4-1.9L SOHC VIN 8 Vehicle Level Powertrain Management Computers and Control Systems Coolant Temperature Sensor/Switch (For Computer) Technical Service Bulletins All Technical Service Bulletins Engine – Driveability Concerns/Cooling System DTC’s Set. SUBJECT: Engine Coolant Temperature Sensor Related Diagnostic Trouble Code(s) and/or the Following Conditions: Hard Start, Erratic Idle, Rough Running. Engine Overheating, Low and/or Leaking Coolant, and/or Service Engine Soon Lamp Illuminated. (Replace Engine Coolant Temperature Sensor with New Design Sensor- P/N 21025106) MODELS AFFECTED: 1991-2001 Saturn S-Series vehicles CONDITION: Customers may comment about various driveability and/or engine operating concerns including: hard start, erratic idle, rough running, engine overheating, low and/or leaking coolant, and/or Service Engine Soon lamp illuminated. CAUSE: This condition may be caused by a cracked engine coolant temperature sensor. CORRECTION: Replace engine coolant temperature sensor, inspect and if necessary replace sensor harness connector. Refer to procedure in this bulletin to replace engine coolant temperature sensor and Parts Requirements for specific parts information.… Read More
Download 1999 Saturn SL Engine – Driveability Concerns/Cooling System DTC’s Set
Filed Under (Ford) by Doe Namblas on 31-12-2013
Download PRODUCT ACCESSORIES DESCRIPTION The 1100F interface module is used when installing remote start products in Ford vehicles equipped with a factory immobilizer. The 1100F allows for easy interfacing between the remote start and the factory immobilizer, while maintaining the integrity of the OEM system. The factory transponder-based anti-theft system uses a small electronic chip hidden in the key to send a code to the vehicle’s transceiver when the ignition is energized. The key must be placed in the ignition and turned to the RUN position. This energizes a coil surrounding the key, which in turn energizes the chip, which sends a code to the vehicle. If the vehicle does not detect the code being sent, the vehicle will start and then immediately shut off or will just crank, and the anti-theft light will flash. The 1100F provides a valid code to the vehicle whenever it is remote started, but does not affect the immobilizer system during normal vehicle operation; the immobilizer system remains fully functional.… Read More
Download 1100F FORD PATS / SECURILOCK REMOTE START INTERFACE-DATA
Filed Under (Chevrolet (Chevy)) by Doe Namblas on 24-02-2014
Download Subject: 07187C — SPECIAL COVERAGE ADJUSTMENT – INSTRUMENT PANEL CLUSTER GAUGE NEEDLE FUNCTION Models: 2003-2004 CADILLAC ESCALADE, ESCALADE ESV, ESCALADE EXT 2005 CADILLAC ESCALADE, ESCALADE ESV, ESCALADE EXT (U.S. ONLY) 2003-2004 CHEVROLET AVALANCHE, SILVERADO, SUBURBAN, TAHOE 2005 CHEVROLET AVALANCHE, SILVERADO, SUBURBAN, TAHOE (U.S.ONLY) 2003-2004 GMC SIERRA, YUKON, YUKON XL 2005 GMC SIERRA, YUKON, YUKON XL (U.S. ONLY) Condition Some customers of all 2003-2004 model year and certain U.S. 2005 model year Cadillac Escalade, Escalade ESV, and Escalade EXT; Chevrolet Avalanche, Silverado, Suburban, and Tahoe; and GMC Sierra, Yukon, and Yukon XL vehicles have reported that one or more of the instrument panel (IP) cluster gauges stick, flutter, or become inoperative. This may cause inaccurate readings, including the speedometer and fuel gauge. Special Coverage Adjustment This special coverage covers the condition described above for a period of 7 years or 70,000 miles (110,000 km), whichever occurs first, from the date the vehicle was originally placed in service, regardless of ownership.… Read More
Download 2005 Chevrolet Chevy K Silverado Panel Cluster Gauge Needle Function
Filed Under (Other Manuals) by Doe Namblas on 01-01-2014
Download Models: 2004-2007 Buick Rainier 2003-2006 Chevrolet Avalanche, Suburban, Tahoe 2003-2007 Chevrolet Silverado Classic, TrailBlazer, TrailBlazer EXT 2003-2006 GMC Yukon, Yukon XL 2003-2007 GMC Envoy, Envoy XL, Sierra Classic 2003-2004 Oldsmobile Bravada 2005-2007 Saab 9-7X with Four Wheel Drive or All-Wheel Drive and Active All-Wheel Drive (RPO NP4) or Active Two-Speed (RPO NP8) Transfer Case. Condition Some customers may comment on intermittent illumination of the Service 4WD light. Upon investigation, the technician may find DTC C0374 set. The customer may also comment on intermittent erratic operation of the 4WD or AWD system after driving through rain/snow or simply going through a car wash. Cause The speed sensor signal may have become corrupted. Possible openings in the speed sensor wire insulation (twisted pairs) can allow water intrusion. Also, wire connections contaminated by water may result in short circuits and erroneous speed sensor readings. This most often occurs on the rear speed sensor circuit.… Read More
Download Service 4WD Light Illuminated, DTC C0374 Set (Inspect Wiring Harness to Transfer Case Speed Sensors, Replace Wiring Harness)