2002 Isuzu Truck Axiom Service and Repair

0

Filed Under (Isuzu) by admin on 06-03-2014

Download 2002 Isuzu Truck Axiom 2WD V6-3.5L Vehicle Level Transmission and Drivetrain Automatic Transmission/Transaxle Fluid – A/T Service and Repair. Changing Transmission Fluid There is no need to change the transmission fluid unless the transmission is used under one or more of the following heavy duty conditions. A. Repeated short trips B. Driving on rough roads C. Driving on dusty roads D. Towing a trailer If the vehicle is used under these conditions, change the fluid every 20,000 miles (32,000 km). 1. Place a large drain pan under the oil pan. 2. Remove the transmission oil drain screw (2) and drain fluid. 3. Tighten drain screw (2). Torque: 38 Nm (28 ft. lbs.) 4. Remove the transmission overfill screw (1) and fill transmission through overfill screw opening, using DEXRON-III ATF. Note: Add transmission fluid until it flows out over the overfill screw opening. 5. Let engine idle until a fluid temperature between 32°C (90°F) and 57°C (135°F) is reached. 6. Add transmission fluid until it flows out over the overfill screw opening, then close the overfill screw (1). Torque: 38 Nm (28 ft. lbs.) Note: To prevent fluid leaks, the overfill screw and oil drain screws gasket must be replaced each time these screws are removed. Note: Check transmission fluid temperature with scan tool. 7. Reset “Oil Life Monitor” data by using Tech 2. Refer to Tech 2 OBD II Connection in Transmission Control System (4L30-E).

Incoming search terms:

2012 isuzu nqr air temp sensor , automatic transmission shifter cable 2002 isuzu axiom , isuzu axiom 2002 transmission flush recommendation

Comments are closed.

You might also likeclose