Filed Under (Ford) by admin on 16-10-2013

Download FORD: 2005-2010 Mustang. This article supersedes TSB 8-2-10 to update the production fix date, vehicle model years and part list. ISSUE Some 2005-2010 Mustang vehicles built before 4/5/2009 and equipped with a 4.6L engine and manual transmission, may exhibit an oil-canning or exhaust rattle/buzz around 2000 – 2500 RPM during the first few minutes of driving after a cold start. The sound goes away after the car warms up. The concern may be caused by the separator plate, between the rear face of the engine block and the transmission housing, vibrating and/or contacting the flywheel. ACTION Follow the Service Procedure steps to correct the condition. SERVICE PROCEDURE 1. Remove transmission per Workshop Manual (WSM), Section 308-03B. 2. Pry separator plate from the rear face of the block alignment dowels and slide it out from between block and flywheel. Replace with new service part. 3. Install transmission per WSM, Section 308-03B. Figure 1 – Article 09-18-16 NOTE PART NUMBER PART NAME INSTALL NEW SEPARATOR PLATE TO 8R3Z-7007-B Separator Plate TRANSMISSION BOLTS IF MISSING OR W500231-S439 Bolt DAMAGED. (FIGURE 1)

Incoming search terms:

vt2005 thermostat manual , VT 2005 Thermostat Instructions , manual c4 picaso 2010 , 2005 volvo 780 operations manual , 2005 vnl 780 truck repair manual , 2005 FORD ESCAPE P0732 , 2005 chevrolet suburban 5 3 litre vortec v 8 vin z assembly schematics , tech manual honeywell 2005 , tcc solenoid 08 mustang , steps changing crank sensor 2009 accent , Mazda MPV 2005 Transmission cooling system drawing , manual c4 picasso 2010 , how much for a 2010 chevy traverse block heater , ford mustang TSB on the transmission plate , factory 2005 vnl 780 truck repair manual , door blender AC mustang gt 2010 , acadia Popping Noise When Accelerating , 2014 ram 2500 service manual , 2011 mustang b00a0 , 2005 volvo 780 battery installation , 2005 chevy silerado actuator pinout , 2005 6 0 chevy bus

Comments are closed.

You might also likeclose