Audi A6 4F APS+ Installation guide

By | January 4, 2014

Download Please disconnect the battery before you are going to start the installation! note: This manual is for experienced people in retrofitting. After Installation the system have to be coded by an Audi dealer: Address 76 (Parkassist) – activation of optical display Address 07 (display front) – chanal 01, current value +4 You should check all components you need before installing: wiring control unit – sensors wiring sensors front 4 suitable sensors in the colour of the car control unit PDC for optical display in MMI buzzer front including button PDC For drilling the wholes into the bumper you will need a 23mm driller („Forstnerbohrer”). For fitting the sensors you will need a hot glue gun as well as sandpaper. Parts as follows has to be removed: Bumper front Cover above the wheel left and right Glove box Entry rail right, frint and back Cover B-post right Back seats Cover trunk in the middle Cover trunk right Cover underneath the steering wheel The control unit for PDC is located behind the trunk cover on the right hand side. Remove the middle cover of the trunk. Pull of the metal plate of the trunk. Remove the cover by pulling on the right hand side of the trunk like showing on the image. Remove the back seats. Pull the seats out of the locking. Remove the cover of the B- post. Pull the cover beginning from the ground up to the roof. Pull the lower cover in direction of the roof. It is fixed on the ground. Please remove the glove box. Therefore remove the cover on the right hand side and remove the screws which are located behind. Remove all screws underneath and disconnect all connections behind. Wire the harness starting from back seat in the front direction to the fuse box. Please wire the split to the buzzer and button as well. Please wire the harness up to the trunk in the back and connect it to the control unit. The two loose wires have to be plugged into the brown 16-pole connector which is already part of the harness. The chamber where to plug in the two wires is printed on the wires. Now you can wire the arm for the buzzer and button PDC. Therefore you have to pull the clima control unit (it is quite tough). Remove the cover underneath the steering wheel as well. The button PDC is located above the clima control unit right hand side. The buzzer is located in the footwell area (driver side) on the centerconsole. The wholes for mounting are already there.

Incoming search terms:

Audi ashtray cover , audi undercarriage cover screws , remove audi tt trunk liner , audi undercarriage screw , Audi A4 Undercarriage Cover , how to remove engine cover on 2011 acadia , audi undercarriage cover fasteners , is the 2012 camero battery in trunk , how to remove trunk liner in 2009 audi a4 , how to remove hitch cover buick enclave , PDC bak outlander mitsubishi , 01 a6 replacing skid plate , remove audi a4 protective undercarriage , remove the trunk liner on audi 2000 , remove truck cover from q5 , removing fuse panel reviews on 2014 volkswagen jetta , removing trunk cover Audi Q5 , replace trunk latch on B6 Audi Avant , how to remove a/c compressor from a 2010 buick enclave , how to manually override gear shift Pontiac g6 , How do I access the trunk wiring of an Audi S4 , 1997 audi a4 trunk cd changer wiring harness , 2007 g6 shift lock location , 2012 camaro trunk battery , A4 Avant B6 trunk latch , audi a4 undercarriage cover screws , audi a4 undercarriage protective cover , Audi ashtray , audi radio chorus safe 2 , Camaro painted fuse box cover , chassis disconnect solenoid on 04 workhorse chassis test breaker just clicks , cost to fix a4 avant trunk latch , fuse box panel cover 1995 mitsubishi montero sr , slk320 engine cover removal