Bomz Racing 1994 Acura Integra GSR Intake Installation Guide

0

Filed Under (Acura) by admin on 23-01-2014

Download Removal of Factory Intake 1. Please read through the entire instruction sheet to familiarize yourself with the parts of the vehicle the installation will deal with. 2. Start the engine and check for loose connections or coolant/vacuum leaks. 3. Disconnect the negative battery terminal. 4. Remove the air filter duct, all vacuum hoses, water (coolant) hoses and electrical connectors from the stock throttle body. Mark all hoses and wires to ensure that they are installed correctly on the new throttle body. Note: Engine coolant may run from the hoses once removed. 5. Disconnect the throttle linkage by opening the throttle manually and slipping the cable from the cam groove on the linkage. 6. Remove the four nuts securing the throttle body to the intake manifold and remove it. 7. Remove the MAP sensor from the factory throttle body. Use the new O-ring with the blue stripe from the kit contents to seal the MAP sensor to the throttle body. Attach the MAP sensor to the new throttle body using the factory screws. 8. Remove the idle air control motor from the factory throttle body. Using the factory bolts and the O-rings supplied in the kit, attach the IAC to the new throttle body. The o-rings are color-coded. Torque down bolts to 10 N-m. Note: to achieve the maximum benefits when re-using the factory in take manifold, you should match the opening on the intake manifold to the size of the new throttle body bore. The manifold should be hand-ground OFF the engine and thoroughly cleaned prior to reinstallation. No grinding is needed. These manifolds are already bore-matched to this throttle body. Install of Intake 9. Be certain the gasket-mating surface on the intake manifold is cleand releases the gas pedal to ensure that the throttle blade opens and closes completely as well as smoothly. and free of debris. Using the factory nuts and bolts and the new gasket supplied in the kit, attach the throttle body to the intake manifold. 10. Slip the throttle cable on the linkage arm. 11. Observe the throttle body while an assistant presses an12. Re-attach the air filter duct, all vacuum hoses, coolant hoses and electrical connectors on the new throttle body. 13. Re-connect the negative battery terminal. 14. Start the engine and check for loose connections or coolant/vacuum leaks. 15. After the engine is warmed up, check the idle speed. 16. Double-check all fasteners, clamps, and electrical connections to ensure they are all

Incoming search terms:

do you need to reflash a new throttle body on a 2003 saturn vue , gsr stock intake manifold diagrams , how do you change the throttle body on 2003 v6 saturn vue , how to install a throttle body on a 2003 saturn vue , Intake Manifold Diagram volvo b18 , removing intake cover colorado , using d16y7 auto manifold for manual swap , what is the plastic case next to throttle body on colorado , wher iiis intake air bypass located on a b18 GSR

Comments are closed.

You might also likeclose